Discussions Release Notes Release Notes

November 2020 Release

Change

  • [DEV-2518] - Restructure Org and User Licenses
  • [DEV-2535] - Remove “Component Parameters” from Drawings

Improvement

  • [DEV-2417] - Set up Redis
  • [DEV-2534] - Check for “number of loops” in ECAD features - how many drawing sections are in the sketch?
  • [DEV-2539] - Add prompt in Message Log to prompt Note Selections
  • [DEV-2543] - Improve BOARD_THICKNESS measurement feature

Task

  • [DEV-1882] - Changes to integrations endpoints
  • [DEV-2198] - Create buttons to "Recalculate Compound Designation" and "Recalculate All Compound Designations"
  • [DEV-2209] - Make sure that SettingSync Parameters are counting ParameterProfiles properly through ParameterProfileParameters
  • [DEV-2215] - Make a grid component for being able to search or create a parameter on the fly
  • [DEV-2527] - Migrate settings over to new product tiers

Bug

  • [DEV-2351] - ProMdlTypeGet
  • [DEV-2533] - Measurement features should only create if missing
  • [DEV-2540] - Fwd: Rsys Config - Min Max Segment Length writing improperly
  • [DEV-2555] - Second Config download breaks some list values
  • [DEV-2557] - creo::settingsync::ApplyModelTemplateGUI::GetTableStartPartItems
Comments to this discussion are now closed!
More topics in Release Notes
See all 18 topics
Help Desk Software by Freshdesk Support Desk